AMX Mio Modero Device Family - Manual (Page 26)

Programming The Mio Modero
22 Mio Modero Device Family
Combining Buttons
Use the ^CFG Send Command (see page 18) to combine/uncombine adjacent buttons on the Keypad:
1. Send the following Send Command to the Keypad, to set the Keypad to button combine mode:
SEND_COMMAND Panel,"'^CFG-1'"
2. Hold down two adjacent buttons for 2 seconds.
3. When the two buttons have been pressed for 2 seconds, the LED on the left button will flash to indicate
they are combined.
If you press two buttons that are already combined, they will be uncombined. The indication is that both
button LEDs will flash alternately.
Combine mode can be exited by sending the command '^CFG-0' or by disconnecting the keypad from power to
reboot it.
Sending Firmware to The Mio Modero Keypads
To send firmware to the keypads:
1. Open NetLinx Studio.
2. Go to Tools > Firmware Transfers > Send to Axcess Device... This opens the Send to Axcess Dialog.
Browse to the location of the firmware file.
3. Select the file within the Files frame.
4. Click Query for Devices.
5. Select the Mio Modero Keypad within the Devices frame.
6. Click Send and then Close.
7. Upon confirmation of a successful send, you can exit NetLinx Studio.
The variables for the ^CFG command value are: 1= enter combine mode,
0= exit combine mode.
While in button combine mode, no pushes will be sent.
You will need the NetLinx Studio software application (available to download from
www.amx.com) to update firmware located on the Mio Modero Keypads.