Continuous shot, Metering – Samsung EC-S1050BDA-AS User Manual
Page 48
《47》
Continuous shot
- [Single]
: Take one picture only.
- [Wise Shot]
: 2 images are taken at a time.
One is taken in the Fill-In Flash
mode and the other is taken in
the ASR mode.
- [Continuous]
: Images will be taken
continuously until the shutter
button is released. The shooting
capacity depends on the memory.
- [AEB]
: Take three pictures in a series in different exposures:
standard exposure (0.0EV), short exposure (-1/3EV) and
over exposure (+1/3EV).
- [Motion Capture] : This takes 30 shots per second, when the shutter is pressed
and held down. After completing the continuous shooting,
images are saved and the images play back on the Rear
LCD. The maximum number of shots is 30. Image size is
1024X768 and quality is fixed as normal.
■ You can select continuous shot, and AEB (Auto Exposure Bracketing).
● High resolution and picture quality increases file saving time, which
increases stand-by time.
● Wise shot is available in the ASR mode only(p.16)
● If the [Continuous], [AEB] or [Motion Capture] sub menu is selected, the
flash will be off automatically.
● If less than 3 pictures are available in the memory, the AEB shooting is not
available.
● It is best to use a tripod for the AEB shooting as the time to save each
image file is longer and blurring caused by camera shake may occur.
INFORMATION
[ PROGRAM mode ]
6
Single
DRIVE
Metering
■ If you cannot obtain suitable exposure conditions, you can change the metering
method to take brighter pictures.
- [Multi] : Exposure will be calculated based on an
average of the available light in the image
area. However, the calculation will be
biased towards the centre of the image
area. This is suitable for general use.
- [Spot] : Only the rectangular area in the centre of
the LCD monitor will be metered for light.
This is suitable when the subject in the
centre is exposed correctly, regardless of the back lighting.
※ If the subject is not the centre of the focus area, do not use the spot metering
as this may result in an exposure error. In this circumstance, it is better to use
exposure compensation.
[ PROGRAM mode ]
6
Multi
METERING