Samsung HT-SK6 - Manual (Page 13)

11
Connecting the Speakers
Connect the supplied speaker system using the supplied speaker cords.
- Make all connections with the power turned off to the unit to protect the speakers.
Subwoofer
Left front
speaker
Left rear
speaker Right rear
speaker
Right front
speaker
Center speaker
Check the location of the terminals on the main unit and on the rear of the
speakers before connecting the Front, Rear, and Center Speakers.
- Connect the red cord to the red(+)terminal and the black cord to the black(-) terminal.
- Make sure the positive (+) and negative (-) speaker wires are not mixed.
1
Use the supplied audio cord to connect the SUBWOOFER PREOUT on the
rear of the main unit to the LINE IN on the rear of the speaker. 2
Ideal Speaker Placement
Front Speakers
Center Speaker
Rear Speakers
Subwoofer Speaker
Set the front speakers so that their tweeters (high-range) are
aligned at about ear level and at a horizontal angle of 45° to the
prime listening position.
Ideally the center speaker should be positioned with its top
surface flush with the front speakers. However, you may place
the speaker either on top or near the bottom of your TV set.
Vibration caused by the center speaker can disrupt the picture
if it is placed directly on the television. Put the center speaker
on a rack or shelf.
Place the subwoofer on the floor near the TV or mount it
on a rack, free from vibration and instability.
Set the rear speakers further back, parallel to the walls,
at 60 to 90 centimeters (2 to 3 feet) above prime listening
position ear level.
If the space behind the listening position is insufficient
(i.e., too close to the wall), place the rear speakers facing
each other on either side.
• After installation is complete, tie up or taping down long, loose electrical cords.
• Please refer to the KLIPSCH Operation Manual for details on using the speakers.