To set up speaker balance, Speaker setting methods, Example: 5.1ch sound setup – Samsung HT-SK6 User Manual
Page 39: Press the test tone button, Off, range of – 6 ~ 0, Press the test tone button again
37
To set up Speaker Balance
To set up Speaker Balance
L
C
R
LS
LFE
S
RS
D I G I T A L
L
C
R
LS
LFE
S
RS
D I G I T A L
L
C
R
LS
LFE
S
RS
D I G I T A L
L
C
R
LS
LFE
S
RS
D I G I T A L
L
C
R
LS
LFE
S
RS
D I G I T A L
1
Use the Left/Right ( / ) button to raise or
lower the output level of the chosen
speaker(s).
Example: 5.1CH Sound Setup
OFF, range of – 6 ~ 0
OFF, range of – 6 ~ 0
range of – 6 ~ – 00 ~ +6
range of – 6 ~ – 00 ~ +6
range of – 6 ~ – 00 ~ +6
Front Speakers: L level, R level
Rear Speakers: L level, R level
Center Speaker
Rear Speakers
Subwoofer Speaker
Sound Edit
Press the Sound Edit button. Each time the
button is pressed, the selection switches as
shown below.
▲
▲
2
The display changes depending on the current audio output
mode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).
While in DSP or PRO LOGIC mode, TEST TONE may
operate differently for VCDs or CDs.
Speaker Setting Methods
•
The test signal will be sent to the Left Front
➞
Center
➞
Right
Front
➞
Right Rear
➞
Left Rear
➞
Subwoofer in that order.
Test Tone
Press the Test Tone button.
To End the Speaker Setup
Test Tone
•
Press the Test Tone button again.
L
LS
RS
C
SUB
WOOFER
R