Samsung RSG309AARS-XAA - Manual (Page 11)

English - 11
01
SETTING
UP
Removing the Fridge Door
1. Remove a screw on the upper hinge cover
( 1 ). With the door open, disengage the two
locking tabs with a flat-head screw driver ( 2 )
and remove it while the lifting up the rear of the
cover (
3 ), and then disconnect the wires by
gently pulling them apart ( 4 ).
3
2
4
1
2. Removing the FIXER HINGE ,and next take off
the upper hinge. Be careful that the door does
not fall on you as you are removing it.
Be sure to keep track of all parts you are
removing.
3. Remove the door from the
lower hinge ( 5 ) by lifting
the door straight up ( 6 ).
6
5
Reattaching the Fridge door
To reattach the fridge doors, replace parts
in reverse order.
LEVELLING THE REFRIGERATOR
Now that the doors are back on the refrigerator,
you want to make sure the refrigerator is level
so that you can make final adjustments. If the
refrigerator is not level, it will not be possible to get
the doors perfectly even.
When the Freezer part is lower than the
Fridge part.
Insert a flat-blade screwdriver into a slot on the
Freezer Leg, then turn it clockwise.
Freezer Leg Screw Driver
When the Fridge part is lower than the
Freezer part.
Insert a flat-blade screwdriver into a slot on the
Fridge Leg, then turn it clockwise.
Fridge Leg Screw Driver
Refer to the next section for the best way
to make very minor adjustments to the
doors.
DA68-02500B-13.indb 11 13. 12. 4. �� 7:12