Samsung RSG309AARS-XAA - Manual (Page 15)

English - 15
01
SETTING
UP
Removing residual matter inside the
water supply line after installing filter.
1. Turn ON the main water supply.
2. Press the Water button and push the Dispenser
Lever.
3. Flush 1 gallons of water through the filter before
use. (Flush approximately 6 minutes.) This will
clean the water supply system and remove air
from the lines.
4. Additional flushing may be required in some
households.
5. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
Ice Water
A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser.
This is due to air getting into the line. It
should pose no problem to operation.
Check the amount of water supplied to
the ice tray.
1. Lift up the icemaker cover and gently pull it out.
2. When you press the Test button for 3 seconds,
the ice cube container is filled with water from
the water supply tap.
Check to make sure the amount of water is
correct (see the illustration below).
If the water level is too low, the ice cubes will
be small.
This is a water pressure problem from within
the main water pipes, not the refrigerator.
1
2
Ice maker
Check the water
level
Test button
• It will take a few minutes to reach the
amount of water you want.
• Do not press the test button continuously when
the tray is filled with ice or water.
Water may overflow or ice jamming may occur.
• When the bucket is not installed, the ice maker
does not work.
• When “Ice maker will not work when the ice
bucket is not installed” message appears on
the display panel, reinsert the bucket and/or
make sure it’s installed properly.
CAUTION
DA68-02500B-13.indb 15 13. 12. 4. �� 7:12