Setting up the refrigerator, Setting up the refrigerator doors – Samsung RSG309AARS-XAA User Manual

Page 9

Advertising
background image

English - 09

01

SETTING

UP

When moving your refrigerator

To prevent floor damage, be sure the front levelling
legs are in the up position (above the floor).
Refer to ‘Levelling the refrigerator’ in this manual
(page 11).
To protect the finish of your flooring while you are
installing the refrigerator, place a large section of
the cardboard carton under the refrigerator where
you are working.

Leg

Screw Driver

When installing, servicing or cleaning
behind the refrigerator, be sure to pull the
unit straight out and push back straight in
after finishing.

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your
Refrigerator should be fully operational.
If not, first check the power supply and electricity
source or try the troubleshooting section at the
back of this user’s guide.
If you have any further questions, contact your
Samsung Electronics service center.

1. Place the Refrigerator in an appropriate location

with reasonable clearance between the wall
and the Refrigerator.
Refer to installation instructions in this manual.

CAUTION

2. Once the Refrigerator is plugged in, make sure

the interior light comes on when you open the
doors.

3. Set the Temperature control to the coldest

temperature and wait for an hour.
The Freezer will get slightly chilled and the
motor will run smoothly.

4. After powering the Refrigerator, it will take a few

hours to reach the appropriate temperature.
You can store food and drinks in the
Refrigerator after the temperature is sufficiently
cool.

SETTING UP THE REFRIGERATOR
DOORS

If your entrance won’t allow the refrigerator to pass
easily through it, you can remove the doors.

Separating the Water Supply Line from

the Refrigerator

1. Pull the two water lines (which are in the Fixer)

out to the front.

2. Remove two water lines (White one is for water

and the other one is for ice) by pressing the
coupler ( 

1 ) and pulling the water line ( 2 )

away.

1

2

Make sure the color of the water lines
match.

DA68-02500B-13.indb 9

13. 12. 4. �� 7:12

Advertising