Samsung RSG309AARS-XAA - Manual (Page 13)

English - 13
01
SETTING
UP
Connecting to the water supply line
1. First, shut off the main water supply line and
turn the ice-maker off.
2. Locate the nearest cold, drinking water line.
3. After connecting the water supply with water
filter, turn on water supply and Flush 3 gallons
through filter before use (flush approximately 6
minutes).
Water line installation kit
Cold water line
Pipe clamp
Shut off valve
INSTALLING THE WATER LINE
Connecting the water line to the
Refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
• ¼” compression nut
• copper tubing • plastic tubing
• ferrule
Compression Nut
(1/4”) (Assembled)
Ferrule
(Not supplied)
Plastic Tubing
(Assembled)
Compression
Fitting (Assembled)
Bulb
Compression
nut (B) (1/4”)
(Not supplied)
or
Copper tubing
(Not supplied)
Plastic tubing (B)
(Not supplied)
Household water supply line
Refrigerator
1. Connect the household water line to the
assembled compression fitting.
- If you are using copper tubing, slip the
compression nut ( B ) (not included) and ferrule
(not included) on copper tubing (not included)
as shown.
- If you are using plastic tubing ( B ), insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
Do not use without the molded end (Bulb)
of the plastic tubing (
B ).
2. Tighten the compression nut ( B ) onto the
compression fitting.
Do not over-tighten the compression nut (
B ).
3. Turn water on and check for any leakage.
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the
water line, cut off 1/4“ of the plastic tubing
to make sure you get a snug, leak-free
connection.
CAUTION
DA68-02500B-13.indb 13 13. 12. 4. �� 7:12