Samsung SC-HMX10C-XAA - Manual (Page 19)

11_ English
INSTALLING THE BUTTON TYPE BATTERY
Installing the button type battery in the remote control
1. Turn the battery holder counterclockwise (as indicated with
() mark) using your fi ngernail or a coin to open it. The
battery holder opens.
2. Insert the battery into the battery holder while the positive
(+) terminal facing down and press it fi rmly until you hear a
locking sound.
3. Place the battery holder back in the remote, match its ()
mark with the () mark on the remote control, and turn the
battery holder clockwise to lock it.
Precautions regarding the button type battery
• There is a danger of explosion if button type battery
is incorrectly replaced. Replace only with the same or
equivalent type.
• Do not pick up the battery using tweezers or other metal
tools. This will cause a short circuit.
• Do not recharge, disassemble, heat or immerse the battery
in water, to avoid the risk of explosion.
WARNING
Keep the button type battery out of the reach of the children.
Should any battery be swallowed, consult a doctor immediately.
USING THE CRADLE
The cradle is a connection plate which can be used to make the camcorder
more stable when charging the battery, or connecting
to an external devices (TV, PC, etc.).
• If you connect your HD camcorder to the
provided cradle using more than one type
of cable to output image, the order of
priority of the output signal is as follows:
USB cable  Component /Multi-AV cable.
• Do not connect the connection cables at
the same time, it may cause confl ict and
may not work properly.
If this occurs, remove all the connected
cables and try the connection again.
臺灣 _ 11
安裝鈕扣電池
在遙控器中安裝鈕扣電池
1. 使用手指甲或硬幣以逆時針方向旋轉電池座（按照指
定的 ( ) 標記）將其開啟。電池座開啟。
2. 將電池正極 ( + ) 端向下插入電池座中，並用力按下它
直到聽到鎖定聲為止。
3. 將電池座置於遙控器後部，與遙控上的 () 標記吻合
（具有 ( ) 標記），然後按順時針方向旋轉電池座將其
鎖定。
有關紐扣電池的注意事項
• 如果沒有正確更換鈕扣電池，將會有爆炸的危險。請
使用相同類型的電池來更換。
• 切勿使用鑷子或其他金屬工具取出電池。這樣可能會
引起短路。
• 切勿充電、拆解、加熱或將電池浸泡在水中，以防爆
炸危險。
警告
請勿讓兒童接觸到鈕扣電池。
若不慎吞下電池，請立刻求醫。
使用托架
托架是接線板，當對電池充電或連接至外接式裝置（電視機、電腦等）
時可用來使攝錄放影機更穩定。
• 如果您將 HD 攝錄放影機連接至提供
的使用多個纜線類型輸出影像的托架
上，則輸出信號的優先順序如下：
USB 纜線
 元件 /Multi-AV 纜線。
• 切勿同時連接纜線，否則可能造成衝
突並無法正確操作。如果發生此情況，
請移除所有連接的纜線，然後再次嘗
試連接。
Battery
holder
1
2
3
DC IN jack
USB jack Component/Multi-AV jack
Cradle
receptacle