Using the menu items, 使用選單項目 – Samsung SC-HMX10C-XAA User Manual
Page 70
62_ English
using the menu items
Fade in
Press the
Recording start/stop button when “Fader” is set to “On.”
Recording starts with a dark screen and then the image and sound are
faded in. (fade in).
Fade out
When you want to stop recording with fade out,
set
“Fader” to “On” again during recording.
Press the
Recording start/stop button.
Recording stops as the image and sound are
faded out. (fade out).
Digital Zoom
You can select the maximum zoom level in
case you want to zoom to a level greater than
10X (the default setting) during recording. Note
that the image quality decrease when you use
the digital zoom.
Settings
Contents
On-screen
display
Off
Up to 10X zoom is performed optically.
None
On
Up to 10X zoom is performed optically, and after
that, up to 2X zoom is performed digitally. (Zooming
more than 10x is achieved digitally, up to 20x when
combined with optical zoom.)
None
•
The image quality may deteriorate depending on how much you zoom
in on the subject.
•
Maximum zooming may result in lower image quality.
•
This function will be set to “
Off” in the EASY Q mode.
•
Digital Zoom function is not available when “
Anti-Shake (EIS)” is “On.”
But, when setting “
Anti-Shake (EIS)” to “On” with Digital Zoom on,
Digital Zoom is released automatically.
•
Digital Zoom is released automatically when Component or HDMI cable
is connected.
This right side of the bar shows the digital zooming factor.
The zooming zone appears when you select the zooming level.
10
10
臺灣 _
62
使用選單項目
右列顯示數位縮放比。
在選擇縮放級別時,會顯示縮放範圍。
淡入
按下
錄製開始
/ 停止按鈕(在「Fader」設定為「On」時。)
錄製以黑螢幕開始,然後淡入影像和聲音。
淡出
在想停止淡出錄製時,可在錄製時再次將
「
Fader」設定為「On」。按下錄製開始 / 停止
按鈕。
在淡出影像和聲音時錄製停止。(淡出)。
Digital Zoom
如果您想在錄製時放大至高於 10X(預設設定)
的級別,可選擇最大縮放桿。請注意,在使用
數位縮放時,影像品質會降低。
設定
內容
畫面顯示
語言
Off
可透過光學方式執行高達 10X 的縮放。
無
On
可透過光學方式執行高達 10X 的縮放,並透過數位方
式執行高達 2X 的縮放。(使用數位變焦可放大 10 倍以
上,與光學變焦配合最多可放大 20 倍。)
無
• 影像品質可能因為您對主體的放大程度而降低。
• 最大程度的縮放可能會導致較低的影像品質。
• 在 EASY Q 模式下,此功能將被設定為「
Off」。
• 當「
Anti-Shake (EIS)」設定為「On」時,數位縮放功能不可用。 但如
果在數位縮放開啟的情況下將「
Anti-Shake (EIS)」設定為「On」,則
會自動退出數位縮放。
• 如果連接了元件或 HDMI 線纜,數位縮放就會自動退出。
Fade in (approx. 3 seconds)
Fade out (approx. 3 seconds)