Samsung RF34H9960S4-AA - Manual (Page 16)

English - 16
6. Attach the front of the Top Cover, and then
press down on its back until it lies fl at. Re-
attach the screws.
• Assemble the Fridge and Freezer doors
in the reverse order of disassembly.
• If the Wire Connectors are cross-assembled,
the display will not work properly.
• Clips are located inside the cap on the top.
• To prevent water leaks, if the refrigerator uses
red clips, make sure the red clips are properly
connected to the Coupler after you insert the
Water Tube [E] into the center of the Coupler.
Center of the Center of the
Indicator Line Indicator Line
clip A clip A
(6.35 mm) (6.35 mm)
E E
• Keep the clips out of the reach of
children and make sure that children do
not play with them or put them into their
mouths.
CAUTION
CAUTION
LEVELING THE REFRIGERATOR
AND ADJUSTING THE DOOR
HEIGHT AND THE GAP BETWEEN
THE DOORS
HOW TO LEVEL THE REFRIGERATOR
If the Refrigerator is not level, it can cause a height
difference between the doors.
• Insert a Flat-Head (-) Screwdriver into the slot in
the Leveling Leg Control Lever and adjust the
level by turning the Control Lever clockwise or
counter-clockwise. When you rotate the Lever
clockwise, you raise the refrigerator. When you
rotate the Lever counter-clockwise, you lower
the refrigerator.
fl at-blade fl at-blade
screwdriver(-) screwdriver(-)
Control Lever Control Lever
• If the Refrigerator is not level back and
front, put a solid panel (such as a plastic
panel, a plastic ruler, etc.) on the fl oor
where the rear legs will rest, and then fi x
it in place with plastic tape. When you
push in the Refrigerator, make sure the
rear legs rest on the panel.
• If you have a wooden fl oor or similar soft fl oor,
take care not to damage the fl oor when pushing
the Refrigerator into place.
DA68-03013A-05.indb 16 DA68-03013A-05.indb 16 2014. 5. 28. 10:08 2014. 5. 28. 10:08