How to adjust the door height, How to adjust the door gap – Samsung RF34H9960S4-AA User Manual

Page 17

Advertising
background image

English - 17

SETTING UP

HOW TO ADJUST THE DOOR
HEIGHT

If any one of the doors is lower
than the other:
• Check if the Refrigerator is

level before adjusting the
door.

• Adjust the door height

difference by inserting a
Snap Ring (

1

1

) as shown

between the door and the
hinge. You can use the rings
to raise the right side door of
the fresh food compartment
and both doors of the freezer
compartment.

1

1

• After checking the height difference, select one

Snap Ring with a suitable thickness.
Important: You can only insert one snap ring.
Inserting two or more Snap Rings may cause
the Snap Rings to slip out or make a rubbing
noise.

• Lift up the lower door and insert the Snap

Ring into the space between the Door and the
Hinge.

• To avoid injury, insert or remove Snap

Rings carefully.

• Keep the Snap Rings out of the reach of

children and make sure that children do not
play with them or put them into their mouths.

• 1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap

Rings come with the Refrigerator.

• If the Refrigerator is level before you load

it with food, the Refrigerator may become
unbalanced due to the weight of the food. If this
occurs, adjust the level again using the same
procedure.

• If you raise the door too far, it can rub against

the Top Cover.

CAUTION

Snap Rings included with the refrigerator:

1 mm

1 mm

1.5 mm

1.5 mm

2 mm

2 mm

2.5 mm

2.5 mm

HOW TO ADJUST THE DOOR GAP


If the gap between the left and right fridge
compartment doors is not even.

• You can adjust the gap by

turning the bolt at the top
right of the cold storage
compartment door.

• Do not turn the bolt too far.

You can break it.

1. With the doors closed, remove the 6 screws

holding the top cover using a Phillips
screwdriver, and then lift it off together with the
connected cables.

2. Turn the bolt with a 4 mm

hexagonal L-wrench to
adjust the gap.
(Not provided)

3. Turn the bolt clockwise to ( 

 ) widen the

gap. Turn the bolt counter clockwise ( 

 ) to

narrow the gap.

DA68-03013A-05.indb 17

DA68-03013A-05.indb 17

2014. 5. 28.

10:08

2014. 5. 28.

10:08

Advertising
This manual is related to the following products: