Downloading to an auto-running panel, Adding a relay unit – AMX Novara 1000 Series User Manual
Page 83
AMX NOVARA DCS1000 Device Configuration Software
77
Novara ControlPads & KeyPads
Downloading To an Auto-running panel
To configure a panel that is currently Auto-running, the panel must be powered down and the program
Downloaded within the first five seconds of power up before the panel starts auto-running again.
Adding a Relay Unit
1.
Connect the relay unit to the Relay port on the ControlPad (see the Relay 1 / Relay 2 Connectors section
on page 10).
2.
Click the Add Relay button in the Command Bar to invoke the Select Relay window (FIG. 90).
3.
Select the relay to control from the Select Relay drop-down menu (Relay 1 or Relay 2).
4.
Select the relay action type from the Select Action drop-down menu.
On will latch the relay on,
Off will latch the relay off.
5.
When the parameters have been set click on Add to Script.
FIG. 90
Select Relay window