AVerMedia Technologies EYES PRO MP3000 - Manual (Page 66)

AVerMedia User’s Manual
EYES Pro/MP2016/MP3000/MP5000
123
Preset Position Setup
Each PTZ camera can set 16 preset positions. You can move the camera
to a desired preset position simply by clicking on the number of the
preset position. To set a preset position, first select the number of the
preset position and set the direction speed. Then configure the
camera’s position with the directional control buttons, focus in/focus out
buttons, and zoom in/zoom out buttons. Finally set the stay time,
rotation speed, and click the Save button.
Direction Control
Adjust the camera’s direction with the following eight buttons; Up /
Down / Left / Right / Upper Left / Bottom Left / Upper Right / Bottom
Right.
Direction Speed
There are four speeds to decide the moving speed of the PTZ camera
during adjusting Direction Control
Focus in
Decrease the focal length of the camera to focus on the image.
Focus out
Increase the focal length of the camera to focus on the image.
Zoom in
Zoom in to enlarge the image of the object.
Zoom out
Zoom out to reduce the image of the object.
AVerMedia User’s Manual
EYES Pro/MP2016/MP3000/MP5000
124
Dwell (Sec)
During AutoPan, this button determines the time for the camera to stay
(1~60 seconds) at one position before rotating to the next position.
Rotation Speed (deg/s)
You can set the speed (5~255 deg/s) by the left and right arrows at
which the camera rotates from its current position to the next preset
position.
Save
After you finish setting a preset position, you need to click this button to
save it and go on to set the next preset position.
Clear
Click this button to clear the setting for the current preset position.
Group
Each PTZ camera has 4 groups to comply with the position sequences
as follows:
Group 1: 1~4 positions Group 2: 5~8 positions
Group 3: 9~12 positions Group 4:13~16 positions
AutoPan
Choose a group number first, and click this button to enable this
function.
Back to Main Menu
Click here to back to main menu.