AVerMedia Technologies EYES PRO MP3000 - Manual (Page 8)

AVerMedia User’s Manual
EYES Pro/MP2016/MP3000/MP5000
7
MP3016 Video card MP2016 Video card
Fig. 1 Fig. 2
1. Remove the computer cover.
2. Remove the I/O brackets for the four PCI expansion slots. Save the
screws.
3. Align AVerMedia video card connector with the available PCI slots.
4. Screw AVerMedia video card and the 3 daughter cards respectively
into the rear panel with the screws. See the Fig.1.
5. Connect the 3 daughter cards to AVerMedia video card with ribbon
cables. See the Fig.2.
6. Replace the computer cover and reconnect all cables.
NOTE: Orient the
red mark upward.
PCI Slot
AVerMedia User’s Manual
EYES Pro/MP2016/MP3000/MP5000
8
1.6 Connecting the AVerMedia Video Cards
Up to four cameras can be connected to each AVerMedia video card -
one camera per BNC terminal.
1.7 Attaching Cameras
Cameras must be attached to the BNC connectors of the server video
cards in a specific order to avoid transmission problems. Video cards
are stacked vertically into the chassis. If all four video cards are
installed, the rear panel of the server will appear as shown in the
diagrams below.
EYES Pro MP2016/MP3000/MP5000
1
5
9
13
2
6
10
14
3
7
11
15
4
8
12
16
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
D-type 15-pin
Connector Cable
(Optional)
Coaxial Cable
(Not Supplied)
Camera 1
Camera 2
Camera 3
Camera 4
Infrared Sensor
Proximity Sensor
Smoke Detector
Reed Switch
Relay Control
Burglar Alarm
Access Control Lock
Sensor Inputs
Relay Outputs