Alpine CDM-7858R - Manual (Page 21)

19
-EN
Lock pin
3
Slide the CDM-7859R/CDM-7858R/CDM-7856R
into the dashboard. When the unit is in place,
make sure the locking pins are fully seated in the
down position. This can be done by pressing
firmly in on the unit while pushing the locking pin
down with a small screwdriver. This ensures that
the unit is properly locked and will not accidentally
come out from the dashboard. Install the
Detachable Front Panel.
Removal
1
Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to
push the locking pins to the “up” position (see
Fig. 3). As each pin is unlocked, gently pull out
on the unit to make sure it does not re-lock
before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Front frame
Dashboard
Installation
1
Remove the Detachable Front Panel (refer to
page 4). Slide mounting sleeve from main unit
(see Removal Procedure below). Slide the
mounting sleeve into the dashboard.
2
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the CDM-
7859R/CDM-7858R/CDM-7856R and put the
Rubber Cap on the hex bolt. If your vehicle does
not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Connect all the leads of the CDM-
7859R/CDM-7858R/CDM-7856R according to
details described in the CONNECTIONS section.
NOTE
For the screw
∗
, provide a proper screw to the chassis
installing location.
Rubber Cap
(Included)
Bracket
Mounting sleeve
(Included)
CDM-7859R/CDM-7858R/
CDM-7856R
Hex Bolt
(Included)
∗
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut (M5)
CDM-7859R/CDM-7858R/
CDM-7856R
Screws (M5
×
8)
(Included)
CDM-7859R/CDM-7858R/
CDM-7856R
Mounting Bracket