Alpine CDM-7858R - Manual (Page 8)

6
-EN
Basic Operation
BAND
f UP
g DN
BASS C. TREBLE C. SETUP
1 2
Setting the Bass Control
You can change the Bass Frequency emphasis
to create your own tonal preference.
1
Press the BASS C. button to turn on the Bass
setting mode.
2-1
Setting the Bass frequency:
Press the g DN or f UP button to select
the desired Bass centre frequency.
60Hz
↔
80Hz
↔
100Hz
↔
200Hz
Emphasizes the displayed Bass frequency
ranges.
2-2
Setting the Bass Band Width (Q-Factor):
Press the BAND button to select the desired
Bass Band Width.
Changes the displayed frequency's band width
to narrow or wide.
2-3
Setting the Bass Level:
Press the
55555
or
66666
button to select the desired
Bass Level (-7~+7).
You can emphasize or weaken the bass
frequency.
NOTES
•
If no buttons are pressed within 5 seconds, the Bass
control setting will be turned off automatically.
•
The settings of the Bass Level will be individually
memorized for each source (FM, MW (LW) and CD)
until the setting is changed. Depending on the
connected devices, some functions and display
indications do not work.
Setting the Treble Control
You can change the Treble Frequency emphasis
to create your own tonal preference.
1
Press the TREBLE C. button to turn on the
Treble setting mode.
2-1
Setting Treble frequency:
Press g DN or f UP button to select the
desired Treble centre frequency.
10kHz
↔
12.5kHz
↔
15kHz
↔
17.5kHz
Emphasizes the displayed Treble frequency
ranges.
2-2
Setting Treble Level:
Press the 55555 or 66666 button to select the desired
Treble Level (-7~+7).
You can emphasize the treble frequency.
NOTES
•
If no buttons are pressed within 5 seconds, the Treble
control setting will be turned off automatically.
•
The settings of the Treble Level will be individually
memorized for each source (FM, MW (LW) and CD)
until the setting is changed. Depending on the
connected devices, some functions and display
indications do not work.
→
WIDE1
→
WIDE2
→
WIDE3
→
WIDE4
(Wide)
← →
(Narrow) ...........................
SOURCE