Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 746)

IGMP Snooping Commands
Software Reference for x310 Series Switches
31.8 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
ip igmp immediate-leave
In IGMP version 2, use this command to minimize the leave latency of IGMP memberships
for specified multicast groups. The specified access list number or name defines the
multicast groups in which the immediate leave feature is enabled.
Use the no variant of this command to disable this feature.
Syntax ip igmp immediate-leave group-list {<access-list-number>|<access-
list-number-expanded>|<access-list-name>}
no ip igmp immediate-leave
Default Disabled by default.
Mode Interface Configuration for a VLAN interface.
Usage This command applies to interfaces configured for IGMP, or IGMP Snooping.
Ensure your VLAN is configured first: see Chapter 16, Configuring VLANs .
Example The following example shows how to enable the immediate-leave feature on the VLAN
interface vlan2 for a specific range of multicast groups
Related Commands ip igmp last-member-query-interval
Parameter Description
<access-list-number> Access-list number, in the range <1-99>.
<access-list-number-expanded> Access-list number (expanded range), in
the range <1300-1999>.
<access-list-name> Standard IP access-list name.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip igmp immediate-leave group-list 34
awplus(config-if)# exit
awplus(config)# access-list 34 permit 225.192.20.0 0.0.0.255