Allied Telesis AT-S79 - Manual (Page 203)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 203
Configuring MAC Based Access Control
To configure a MAC Based Access Control, perform the following
procedure.
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type X to select
802.1x Port Based Access Control Configuration.
The Port Based Access Control Configuration Menu is shown in Figure
49 on page 199.
3. From the 802.1x Port Based Access Control Configuration Menu,
type M to select Auth Mode.
The following prompt is displayed:
Select Port based or Mac based auth mode (P/M) >
4. Type M to select MAC Based Access Control.