Allied Telesis AT-S101 - Manual (Page 108)

Chapter 8: Simple Network Management Protocol (SNMP)
108
Modifying a Host Table Entry
To modify the IP address or community name of an entry in the Host
Table, use the following procedure:
1. From the menu on the left side of the page, select the SNMP folder.
The SNMP folder expands.
2. From the SNMP folder, select Host Table.
The Host Table Page is shown in Figure 32 on page 107.
3. To change an IP Address in the table, replace the old IP address with
a new one.
4. To change the community name, use the pull-down menu to select a
new community name in the Host Table.
5. To activate your changes on the switch, click Apply next to the entry
that you want to modify.
6. From the menu on the left side of the page, select Save
Configuration to Flash to save your changes.