Allied Telesis AT-S101 - Manual (Page 14)

Chapter 1: Starting a Web Browser Management Session
14
Establishing a Remote Connection to the Web Browser Interface
The AT-GS950/8POE switch is shipped with a pre-assigned IP address of
192.168.1.1. You must set your local PC on the same subnet as the pre-
assigned IP address for your initial logon.
After your initial login, you may want to assign a new IP address to your
switch. To manually assign an IP address to the switch, refer to
“Configuring an IP Address, Subnet Mask and Gateway Address” on
page 22. To configure the switch to obtain its IP configuration from a
DHCP server, refer to “Enabling and Disabling the DHCP Client” on
page 27.
You must set your local PC to the same subnet as the preassigned IP
address.
Note
Enhanced stacking, a feature of other Allied Telesis Layer 2 and
Layer 2+ managed switches, is not supported by the AT-GS950/
8POE switch.
To start a web browser management session, perform the following
procedure:
1. Start your web browser.
2. In the URL field of the browser, enter 192.168.1.1 which is the default
IP address of the switch. See Figure 1.
Figure 1. Entering a Switch’s IP Address in the URL Field
Switch’s IP Address