Allied Telesis AT-S80 - Manual (Page 180)

Chapter 15: IP Access List
180 Section I: Using the Menus Interface
3. To enable the IP Access List feature, type S to select Set IP
Restriction Status.
The following prompt is displayed:
Enable or Disable IP Restriction (E/D) >
4. Type E to enable the IP Restriction feature or D to disable the IP
Restriction feature.
By default, IP Restriction feature is disabled.
5. Type Q to select Quit to previous menu and save your changes.
Adding or
Removing IP
Addresses
To add or remove IP addresses from the IP Access List, perform the
following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 26 on page
124.
2. From the Basic Switch Configuration Menu, type L to select IP Access
List.
The IP Access List Menu is shown in Figure 43 on page 179.
3. To add or remove an IP address, type I to select Set IP Address.
The following prompt is displayed:
Add or Delete accessible IP (A/D) >
4. Type A to add an IP address or D to delete an IP address.
The following prompt is displayed:
Enter allowed accessible IP>
5. Type an IP address in the following format:
XXX.XXX.XXX.XXX.
6. Type Q to select Quit to previous menu and save your changes.