Allied Telesis AT-S80 - Manual (Page 47)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 47
The System Reboot Menu is shown in Figure 10.
Figure 10. System Reboot Menu
3. From the System Reboot menu, type O to select Set Reboot Option.
The following prompt is displayed:
Select reboot option (F/I/N)>
4. Type N to select Normal.
Note
The F and I options are described in “Returning the AT-S80
Management Software to the Factory Default Values” on page 51.
5. Type R to select Start Reboot Process.
The following prompt is displayed:
Are you sure you want to reboot the system (Y/N)>
6. Type Y to start the reboot process or N to cancel the reboot.
The switch immediately begins to reload the AT-S80 management
software. This process takes approximately one minute to complete.
You can not manage the device during the reboot. You can log in again
after the reboot is finished if you want to continue to manage the
device.
Main Menu -> System Reboot Menu
Reboot Status: Stop
Reboot Type: Normal
---------------------- <COMMAND> ----------------------------
Set Reboot [O]ption
Start [R]eboot Process
[Q]uit to previous menu
Command>