Creating a port trunk, Figure 14. advanced switch configuration menu – Allied Telesis AT-S80 User Manual
Page 64
Chapter 5: Port Trunking
64
Section I: Using the Menus Interface
Creating a Port Trunk
This procedure explains how to create a port trunk.
Caution
Do not connect the cables to the ports on the switches until after you
have configured the trunk with the management software.
Connecting the cables before configuring the software can create a
loop in the network topology. A loop can cause a broadcast storm
and poor network performance.
To create a port trunk, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 14.
Figure 14. Advanced Switch Configuration Menu
2. From the Advanced Switch Configuration Menu, type T to select
Trunk Configuration.
Main Menu -> Advanced Switch Configuration Menu
[V]LAN Management
[T]runk Configuration
[I]GMP Snooping Configuration
Static Multicast [A]ddress Configuration
Quality of [S]ervice Configuration
Port [M]irroring Configuration
[D]ial-in User Configuration
802.1[X] Port Based Access Control Configuration
[Q]uit to previous menu
Command>