Allied Telesis AT-S62 - Manual (Page 188)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 188
Configuring the SNMPv3 User Table
You can create, delete, and modify an SNMPv3 User Table entry. See the
following procedures:
❑ Creating a User Table Entry on page 188
❑ Deleting a User Table Entry on page 191
❑ Modifying a User Table Entry on page 191
For reference information about the SNMPv3 User Table, refer to the
AT-S62 Menus Interface User’s Guide..
Creating a User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
User Table. Then click Configure at the bottom of the page.
The SNMPv3 User Table Page is shown in Figure 59.
Figure 59 SNMPv3 User Table Page