Allied Telesis AT-S62 - Manual (Page 299)

AT-S62 Web Browser Interface User’s Guide
Section VI: Port Security 299
4. To enable or disable the feature, do the following:
a. Click the Enable Port Access check box. A check in the box means
that the feature is activated on the switch. No check means that
the feature is disabled. The default is disabled.
b. Click Apply.
5. If you want to use the RADIUS accounting feature, configure the
parameters in the RADIUS Accounting section of the tab. The
parameter are described below:
Enable Accounting
Activates or deactivates RADIUS accounting on the switch. A check in
the box indicates the feature is activated. No check means the feature
is disabled. The default is Disabled.
Trigger Type
Specifies the action that causes the switch to send accounting
information to the RADIUS server. The choices are:
❑ Start Stop - The switch sends accounting information whenever a
client logs on or logs off the network. This is the default.
❑ Stop - The switch sends accounting information only when a
client logs off.
Port Number
Specifies the UDP port for RADIUS accounting. The default is port
1813.
Type
Specifies the type of RADIUS accounting. The default is Network. This
value cannot be changed.
Enable Update
Controls whether the switch is to send interim accounting updates to
the RADIUS server. The default is disabled. If you enable this feature,
use the next option to specify the intervals at which the switch is to
send the accounting updates.
Update Interval
Specifies the intervals at which the switch is to send interim
accounting updates to the RADIUS server. The range is 30 to 300
seconds. The default is 60 seconds.
6. Click Apply.
7. To permanently save the changes, select the Save Config menu
selection.