Allied Telesis AT-S62 - Manual (Page 228)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 228
A warning message is displayed. Click OK to remove the Target
Parameters Table entry.
6. To save your changes, select the Save Config menu selection.
Modifying a
Target
Parameters Table
Entry
To modify an SNMPv3 Target Parameters Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 77
on page 224.
5. Click the circle next to the Target Parameters Table entry that you
want to change. Then click Modify.
The Modify SNMPv3 Target Parameter Table Page is shown in
Figure 79 on page 228.
Figure 79 Modify SNMPv3 Target Parameters Table Page