Allied Telesis AT-S62 - Manual (Page 467)

AT-S62 Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 467
4. If you selected STP as the active spanning tree protocol, go to
Configuring STP on page 468 for further instructions. If you selected
RSTP, go to Configuring RSTP on page 473. If you selected MSTP, go
to Chapter 24 on page 478.
Note
Once you have configured the spanning tree parameters, perform
Steps 5 through 7 to enable spanning tree.
5. To enable or disable spanning tree, type 1 to select Spanning Tree
Status.
The following prompt is displayed:
Enter new value (E-Enable, D-Disable):
6. Type E to enable spanning tree or D to disable it. The default is
disabled.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.