Allied Telesis AT-8550SP - Manual (Page 65)

AT-8500 Series Fast Ethernet Switch Installation Guide
65
6. If you installed an optional AT-RPS3004 Redundant Power Supply,
connect one end of the DC power cord included with the RPS unit
to the back panel of the AT-RPS3004 device and the other end to
the RPS connector on the back panel of the switch, as shown in
Figure 23.
Figure 23 Connecting the RPS DC Cable
Note
The AT-RPS3004 unit is compatible with all AT-8500 Series switches,
except for the AT-8524POE switch. The latter uses the AT-RPS3104
unit, which was not available at the time of publication of this
document. Do not use the AT-RPS3004 unit with an AT-8524POE
switch.
The switch is now ready for network operations.
No further installation steps are required if you do not intend to
change the default operating parameter settings of the switch,
which are listed in the AT-S62 Management Software User’s
Guide. However, if you want to manage the switch, refer to Starting
a Local Management Session on page 69.