Allied Telesis AT-8550SP - Manual (Page 70)

Installation
70
3. Set the terminal or the terminal emulation program to the
following settings:
❑
Baud rate: 9600 bps
❑
Data bits: 8
❑
Parity: None
❑
Stop bits: 1
❑
Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
Note
When you reset or power cycle the switch during a local
management session, you will see the following prompt: Press
<CTRL>B to go to Boot Prompt
. This message is intended
for manufacturing purposes only. If you inadvertently display the
boot prompt (=>), type boot and press Return to start the switch.
4. Press the Return key.
You are prompted for a user name and password.
5. To view and configure all of the switch’s operating parameters,
enter the login name “manager”. The default password for
manager access is “friend”. To only view the parameter settings,
enter the login name “operator”. The default password for operator
access is “operator”. The user names and passwords are case-
sensitive.
The Main Menu is displayed.
If you logged in with manager access, you can now fully manage
the switch using the management interface. For instructions, refer
to the AT-S62 Management Software User’s Guide or the
AT-S62 Command Line User’s Guide. The guides are available
from the Allied Telesyn web site at
www.alliedtelesyn.com .