Allied Telesis AT-S62 - Manual (Page 558)

Chapter 29: RADIUS and TACACS+ Authentication Protocols
Section VII: Management Security 558
5. To disable the server-based authentication feature on the switch, do
the following:
a. Type 1 to select Server-based Authentication.
The following prompt is displayed:
Server Based User Authentication (E-Enabled, D-
Disabled) ->
b. Type D to disable the feature. The default is disabled.
c. Return to the Main Menu and type S to save your change.
Now that server-based authenticator is disabled, you must
use the standard AT-S62 manager accounts of manager and
operator the next time you log on to the switch to manager it.
6. To configure the TACACS+ client software, do the following:
a. Type 3 to select TACACS+ Configuration.
The TACACS+ Client Configuration menu is shown in Figure
182.
Figure 182 TACACS+ Client Configuration Menu
b. Configure the settings as needed. The settings are described
below:
1 - TAC Server 1
2 - TAC Server 2
3 - TAC Server 3
Use these parameters to specify the IP addresses of up to
three network servers containing TACACS+ server software.
After you have entered an IP address, you will see the
following prompt:
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
User: Manager 11:20:02 02-Jan-2004
TACACS+ Client Configuration
1 - TAC Server 1 .................. 0.0.0.0
2 - TAC Server 2 .................. 0.0.0.0
3 - TAC Server 3 .................. 0.0.0.0
4 - TAC Server Order .............. 1 2 3
5 - TAC Global Secret .............
6 - TAC Timeout ................... 30 seconds
R - Return to Previous Menu
Enter your selection?