Allied Telesis AT-S62 - Manual (Page 726)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 726
Note
If you have selected SNMPv1 or SNMPv2c as the Security Model, you
must select No Authentication/Privacy as the Security Level.
Authentication
This option represents authentication, but no privacy protocol.
Select this security level if you want to authenticate SNMP users,
but you do not want to encrypt messages using a privacy
protocol.You can select this value if you configured the Security
Model parameter with the SNMPv3 protocol.
Privacy
This option represents authentication and the privacy protocol.
Select this security level to allow authentication and encryption.
This level provides the greatest level of security. You can select
this value if you configured the Security Model parameter with
the SNMPv3 protocol.
9. In the Storage Type parameter, select one of the following storage
types for this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the Target Parameters Table to the configuration file.
After making changes to an Target Parameters Table entry with a
Volatile storage type, Save Changes does not appear on the
General Tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the Target Parameters Table to the configuration file. After
making changes to an Target Parameters Table entry with a
NonVolatile storage type, Save Changes appears on the General
Tab.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Target Parameters Table
entry will take effect immediately.
10. Click Apply to update the SNMPv3 Target Parameters Table.
11. To save your changes, return to the General Tab and click Save
Changes.