Aastra Telecom REV 06 - Manual (Page 78)

Features in Release 2.2
74 RN-001029-00, Rev 06, Release 2.2
IP Phone Release Notes 2.2
Ability to Disable Switching Focus to a Ringing Line When on a Call
In Release 2.2, it is now possible to control the behavior of the phone when it
receives an incoming call when it is already in a connected call. By default, and in
the previous release behavior, the phone switches focus to the ringing line to
enable the user to see who is calling them.
In Release 2.2, you can now turn off this functionality so that the phone now stays
focused on the connected call.
You can do this using the “switch focus to ringing
line” parameter in the configuration files or the Aastra Web UI.
Configuring “Switch Focus to Ringing Line” Using the Configuration
Files
You use the following parameter in the configuration files to enable or disable
“Switch Focus to Ringing Line”:
• switch focus to ringing line
Note: If you configure the BLF/Xfer key(s) and/or Speeddial/Xfer
key(s) on the phone, you can enable or disable the switching of the
user interface focus to ringing line while the phone is in the connected
state.
Parameter –
switch focus to ringing line Aastra Web UI: Basic Settings->Preferences->General
Configuration Files aastra.cfg, <mac>.cfg
Description Specifies whether or not the UI focus is switched to a ringing line while
the phone is in the connected state.
Format Boolean
Default Value 1 (enable)
Range 0 (disable)
1 (enable)
Example switch focus to ringing line: 1