Asus Pedestal/5U Rackmount Server TS500-E5 - Manual (Page 62)

Chapter 4: Motherboard information 4-8
9. iBTN RAID setting (3-pin IBTN_SEL1)
This jumper allows you to select the RAID configuration utility to use when
you create disk arrays. Place the jumper caps on pins 1–2 if you install a
PIKE RAID card to the motherboard and want to use the LSI Logic MPT
Setup Utility (default). Or you can place the jumper caps on pins 2–3 to create
the LSI Mega RAID 5 by supported Intel ® ICH9R SATA controller.
®
DS
AN
-D X/ TS
50 0- E5
DSAN-DX/TS500-E5 IBTN setting
2 1 2 3
PIKE RAID5
(Default)
ICH9R RAID5
IBTN_SEL1
8. Intel ® ICH9R SATA port S/W RAID setting (3-pin RAID_SEL1)
This jumper allows you to select the Serial ATA RAID configuration utility to
use when you create disk arrays. Both utilities are supported by the
Intel ® ICH9R. Place the jumper caps on pins 1–2 if you want to use the LSI
Software RAID Configuration Utility (default); otherwise, place the jumper
caps on pins 2–3 to use the Intel ® Matrix Storage Manager (IMSM).
®
DS
AN -D X/ TS 50 0- E5
DSAN-DX/TS500-E5 RAID setting
2 1 2 3
3rd
(Default)
Intel
RAID_SEL1
• LSI Logic MPT Setup Utility is available only when you install a PIKE RAID
card.
• LSI Mega RAID 5 fucntion is available only when you place the iBTN to
I_BTN1 socket.