Allied Telesis AT-MC116XL - Manual (Page 24)

Installing the Media Converter
14
Installing the Media Converter
To install an AT-MC115XL or AT-MC116XL media converter, perform the
following procedure:
1. Remove all equipment from the package and store the packaging material
in a safe place.
Note
Do not remove the dust cover from the fiber optic port until you are
ready to connect the fiber optic cable. Dust contamination can adversely
impact the operating performance of the port on the media converter.
2. If you are installing the media converter on a desktop, attach the four
rubber feet to the bottom of the unit. Refer to Figure 6. Do not attach
the rubber feet if you are installing the unit in an AT-MCR12
chassis.
Figure 6 Attaching the Protective Feet
3. If you are installing the media converter in an AT-MCR12 chassis, refer to
the chassis’s installation guide for instructions on how to install the unit,
then proceed to Step 6.
4. Place the media converter on a flat, secure surface (such as a desk or
table) leaving ample space around the unit for ventilation.