Allied Telesis AT-MC116XL - Manual (Page 25)

AT-MC115XL and AT-MC116XL Installation Guide
15
5. Plug the AC/DC power adapter into an appropriate AC power outlet and
insert the power plug into the DC receptacle located on the back of the
unit. Refer to Figure 7. This step does not apply if you installed the
unit in an AT-MCR12 chassis.
Figure 7 DC Connector
6. Verify that the PWR LED is green. If the LED is OFF, refer to
“Troubleshooting” on page 17 for instructions.
7. Remove the dust cover from the fiber optic connector and connect the
cable to the fiber optic port. Verify that the media converter’s transmitter
port (TX) is connected to the end-node’s receiver port (RX) and that the
media converter’s receiver port (RX) is connected to the end-node’s
transmitter port (TX).
8. Connect the twisted pair cable to the twisted pair port.
9. Set the MDI/MDI-X switch as follows:
— If you are connecting a workstation to the 10Base-T/100Base-TX port,
set the MDI/MDI-X switch to the MDI-X position. (MDI-X is the
default.)
— If you are connecting a hub or switch to the 10Base-T/100Base-TX port,
set the MDI/MDI-X switch to the MDI position.
10. Power on the end-nodes.
11. Depending on your configuration, check that the 10 or 100 LED for both
ports on the media converter are green. If the LEDs are OFF, refer to
“Troubleshooting” on page 17.
The media converter is now ready for use.
DC Receptacle
Back of Media Converter
Power Plug
AC/DC Power Adapter