Aastra Telecom 57i IP Phone - Manual (Page 34)

26 Model 57i IP Phone User Guide
Softkeys
State-Based Softkeys (Bottom Keys only)
On the 57i bottom softkeys, you can configure a specific state to display
when a softkey is being used. Available states you can configure for each
softkey include:
• idle - The phone is not being used.
• connected - The current line is in an active call (or the call is on hold)
• incoming - The phone is ringing.
• outgoing - The user is dialing a number, or the far-end is ringing.
• busy - The current line is busy because the line is in use or the line is set
as “Do Not Disturb”.
The following table identifies the applicable default states for each softkeys
type on the IP phone.
Services Indicates the softkey is set to be used as the
Services key.
Callers List Indicates the softkey is set for accessing the
Callers List.
Directory Indicates the softkey is set for accessing the
Directory List.
Intercom Indicates the softkey is set to be used as the
Intercom key.
Empty Indicates the softkey is configured to force a
blank entry on the IP phone display for a spe-
cific softkey. The soft keys are added in order
(from softkey1 to softkey20) after any hard-
coded keys have been added. If a particular
soft key is not defined, it is ignored.
Softkey Type Default States
None All states disabled.
Line idle, connected, incoming, outgoing, busy
DND idle, connected, incoming, outgoing, busy
Speeddial idle, connected, incoming, outgoing, busy
BLF idle, connected, incoming, outgoing, busy
BLF List idle, connected, incoming, outgoing, busy
XML idle, connected, incoming, outgoing, busy
lcr idle, connected, incoming, outgoing, busy
Directory idle, connected, incoming, outgoing, busy
Callers List idle, connected, incoming, outgoing, busy
Intercom idle, connected, incoming, outgoing, busy