Swiftech FS020 ALL MODELS User Manual
Page 13
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Subject to change without notice
- 13 -
1.
Open valve 2 for a couple of seconds, to allow any
air trapped into the valve to escape. Close valve 2
again.
2.
Now, close valves 3 and 1, and open valve 2.
The system is now full, bled, and ready to use,
as shown in the picture to the right.
3.
Turn off the pump by disconnecting it from
A/C.
4.
With both tubes still inside valves 1 and 3,
carefully place the holding tank below the
computer (on the floor for example)
5.
Disconnect the tubes from valves 1 and 3.
Whatever little liquid was still trapped in the
tubes will flow back into the holding tank
without making a mess :-)
6.
FINALLY, REMEMBER to reconnect the L
wire from the socket to the N\O position on the
switch !
- Intentionally left blank -