Before you begin – Swiftech FS020 ALL MODELS User Manual
Page 4
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Subject to change without notice
- 4 -
BEFORE YOU BEGIN!
Components installation
1.
Open the side-panel #21 by loosening thumb screws #32
2.
Remove the main cross bar #27.
3.
A special memory board cross bar (#37) specific to server applications is provided with the lose parts. It is not shown in the schematic above,
and can be safely discarded in most consumer applications.
4.
Loosen screw #33, and remove the front bezel #1
5.
Remove the top cover #17
You now have full access inside the case to proceed with the installation of your power-supply, motherboard, hard drive (s) and various components.
Pre-installation notes
•
Your cooling circuit is already filled with coolant (95% pure water, 5% Swiftech’s HydrX
high-performance coolant). All you need to do is to
install the water-block to your CPU. Please follow the separate installation guides for AMD
or INTEL
processors.
•
Power to the pump: a spare power cord is provided to supply A/C power to the pump. It needs to be connected to an A/C outlet.
•
Your QuietPower
case ships from the factory pre-configured to order. All you need to do is install your components.