Swiftech FS020 ALL MODELS User Manual
Page 6
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Subject to change without notice
- 6 -
1.
Preparing your Motherboard
a.
Remove the existing heat sink
b.
Carefully clean the CPU.
c.
Lightly coat the CPU with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied using preferably a razor
blade, or a credit card, held between thumb and index at a 45-degree angle.
d.
Install the motherboard inside the case
2.
Installing the MCW5000-P
Water-block in Pentium 4 socket 478 stock retention frame
Step 1
Step 2
Step 3
Position your block inside of the retention
frame, and put both clips in place for the
next steps, by simply slipping the non
thumb-tabbed end of each clip in the
retention frame’s locking holes.
While maintaining the opposite side of the
block to prevent it from tipping over, push
down on the thumb-tab to hook the first clip
to the retention frame’s locking hole.
While still maintaining pressure on the same
side of the block, hook-down the second
clip.
Installation is complete!
1.
Preparing your Motherboard
a.
Remove the existing heat sink
b.
Carefully clean the CPU.
c.
Remove Intel’s stock plastic retention frame by pulling off the push-pin inserts.
d.
Install Swiftech’s provided standoff hardware to your motherboard as described in the following chapter, page 6.
e.
Lightly coat the CPU with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied using preferably a razor
blade, or a credit card, held between thumb and index at a 45-degree angle.
f.
Install the motherboard inside the case