A&D Automatic Blood Pressure Monitor TM-2655P - Manual (Page 5)

SAFETY PRECAUTIONS
WARNING
Grounding
To avoid electrical shock, connect the power cable to a medical electrical outlet having a ground
terminal for grounding the device.
Fuse
To avoid a fire hazard, use only a fuse of the proper type, voltage and current rating as specified on
the rear panel. Never bypass a fuse by shorting across the fuse holder and connectors.
Service
Internal service or adjustment to this device should be performed by a qualified person only. Do not
disassemble or modify the device
Device failure
If a device failure occurs, promptly stop using it. Remove the device from the patient and secure the
patient’s safety. Turn the power off and disconnect the power cable from the electrical outlet. Affix a
notice such as “Out of Order” and “Do Not Use” on the device. Ask the nearest dealer for services
To interpret blood pressure measurements
Only a trained medical professional is qualified to interpret the blood pressure measurements. No
device can replace regular medical checkups by a doctor. A doctor should verify the blood pressure
measurements before making adjustments to medication.
When the device gets wet because of a liquid spill
If the device gets wet, promptly stop using it. Remove the device from the patient and secure the
patient’s safety. Turn the power off and disconnect the power cable from the electrical outlet. Affix a
notice such as “Out of Order” and “Do Not Use” on the device. Ask the nearest dealer for service.
CAUTION
In case of emergency
Press the EMERGENCY STOP switch located on the front of the device. This will release the air in the
arm cuff so that the arm can be removed easily. It also operates if there is a power failure.
To stop the operation at any time
Press the START/STOP switch located on the display panel. The quick exhaust will release the air in
the arm cuff and the arm cuff will become loose.
Maintenance/Inspection
Check all functions periodically. Ask the nearest dealer for this inspection.
Do not disassemble or modify the device.
If the device is used for the first time after an extended period of storage, check the device for proper
operation.
iii