A&D Automatic Blood Pressure Monitor TM-2655P - Manual (Page 17)

5. SETTING THE CLOCK
5-1 Clock Adjustment Mode
The clock is set in the clock adjustment mode. The clock adjustment mode display and switches used are
as shown below:
Fig.10 Switches for setting the clock and the clock adjustment mode display
Table 3 Switches for setting the clock
SELECT switch (1) Press to enter the clock adjustment mode.
(2) (In the clock adjustment mode) Press to select the unit to be
adjusted. The selected unit flashes. Each time the switch is pressed,
the flashing unit changes: from “Year” to “Month”, “Date”, “Hours”,
and “Minutes”.
(3) Press to quit the clock adjustment mode.
switch Press to change the flashing digit(s).
5-2 A Setting Example
The following is the procedure to adjust the clock to 14:07, April 20, 2001.
1. Press the SELECT switch to make the SYSTOLIC display flash.
2. Press the switch to display “01” for 2001.
3. Press the SELECT switch to make the DIASTOLIC display flash.
4. Press the switch to display “4” for April.
5. Press the SELECT switch to make the PULSE display flash.
6. Press the switch to display “20”.
7. Press the SELECT switch to make the hours section of the TIME display flash.
11