A&D Automatic Blood Pressure Monitor TM-2655P - Manual (Page 20)

7. SETTING THE FUNCTIONS
7-1 Function Setting Mode
The TM-2655/TM-2655P is provided with various functions, which allow the user to set the device to suit
the user’s requirements. The functions are set in the function setting mode. The function setting mode
display and switches used are as shown below:
Fig.12 Switches for setting the function and the function setting mode display
Table 4 Switches for setting the functions
switch and SELECT switch Hold down the switch and press the SELECT switch to
enter the function setting mode.
COUNTER switch Press to select the function to set.
switch Press to select the function parameter.
1. Hold down the switch and press the SELECT switch. “f01” appears in the SYSTOLIC pressure
display. This indicates that the monitor is now in the function setting mode.
2. Press the COUNTER switch to select the function number to set. Each time the switch is pressed,
the funciton number changes: from “f01” to “f02” to “f03”.
3 Press the switch to select the function parameter.
4. When the settings are complete, turn the power off and turn it on again. The settings are saved.
14