Spektrum SPM7800 DX7S - Manual (Page 11)

11 SPEKTRUM DX7s • RADIO INSTRUCTION MANUAL
EN
Model Select
The Model Select function is used to change to a different model
memory, typically when switching from the current model. You
can store up to 20 models in the DX7s model memory. Access
the model select function through the System Setup mode or
through Direct Model Access (pressing the Clear and Back
buttons at the same time). Direct Model Access allows you to
access the model select function at any time the main screen or
a telemetry screen is displayed.
SYSTEM SETUP
Model Type
Model Type programs the selected model memory to function
in Helicopter (HELI) or Airplane (ACRO) programming. Always
choose model type before doing any other programming for a
model.
Each model memory can be either HELI or ACRO.
When you change model types (Heli to Acro or Acro to Heli) all
current programming in the selected model memory will reset to
the factory default settings. All previous settings will be lost.
Model Name
Naming a model is normally done during initial setup. Name
a model memory in the Model Name Screen using up to 10
characters (a mix of upper and lower case letters, numbers
and symbols) to identify a model. Assign a name that helps you
quickly identify and select a model memory.
You can modify or change names at any time without affecting
other programming.
Switch Select
The Switch Select function assigns or inhibits switches or the
knob to functions or channels. Functions which you can assign
to switches vary between HELI and ACRO types.
Model Reset
Model Reset is typically used to clear the programming for a
model you will no longer be flying.
Model Reset resets the selected model’s programming to fac-
tory default. No other model memories are affected.
When a model’s memory is reset, all programming for that
model is permanently deleted and cannot be recovered.