Spektrum SPM7800 DX7S - Manual (Page 7)

7 SPEKTRUM DX7s • RADIO INSTRUCTION MANUAL
EN
BINDING
You must bind the receiver to the transmitter before it will operate. Binding teaches the receiver the specific code of the transmitter.
Once bound, the receiver only connects to the transmitter when the previously bound model memory is selected. You will need to
rebind the receiver after the model is set in the transmitter to fully program the model’s failsafe positions. If another model memory
is selected, the receiver will not connect. This feature is called ModelMatch™ and prevents flying a model using the wrong model
memory.
2. 3.
2. 3.
4.
6. 7.
HOLD BUTTON WHILE POWERING ON
Mode 2 Shown
1.
1.
4.
HOLD BUTTON WHILE POWERING ON
Mode 2 Shown
5.
5. 6.
Binding Using the Receiver and Receiver Battery
Binding Using the Receiver and ESC
2. 3.
2. 3.
4.
6. 7.
HOLD BUTTON WHILE POWERING ON
Mode 2 Shown
1.
1.
4.
HOLD BUTTON WHILE POWERING ON
Mode 2 Shown
5.
5. 6.
1. Lower throttle to the lowest position and make sure the
transmitter is powered off.
2. Insert bind plug into the BIND/DATA port.
3. Insert receiver battery into ANY open port. The receiver’s LED
will flash when the receiver is ready to bind.
4. While pressing the Trainer/Bind button, power on the
transmitter.
5. Release the Trainer/Bind button after the receiver has
stopped flashing rapidly, once the receiver’s LED stays
illuminated; this indicates the receiver is bound to the trans-
mitter. The screen also provides binding information.
6. Remove the bind plug from the receiver.
1. Lower throttle to the lowest position and make sure the
transmitter is powered off.
2. Insert bind plug into the BIND/DATA port.
3. Insert ESC plug into the THRO port.
4. Connect battery to ESC and turn on ESC switch, if available.
The receiver’s LED will rapidly flash when the receiver is
ready to bind.
5. While pressing the Trainer/Bind button, power on the trans-
mitter.
6. Release the Trainer/Bind button after the receiver has stopped
flashing rapidly, once the receiver’s LED stays illuminated;
this indicates the receiver is bound to the transmitter. The
screen also provides binding information.
7. Remove the bind plug from the receiver.