Spektrum SPM7800 DX7S - Manual (Page 9)

9 SPEKTRUM DX7s • RADIO INSTRUCTION MANUAL
EN
SYSTEM SETTINGS
Use the System Setting screen to establish the overall transmitter setting that will apply to ALL model memories. These settings
include: User Name, Contrast, Mode, Region and Language. If you select Mode One, then Mode One will be selected for all 20 model
memories. Even when models are imported from an SD card, the system settings in the transmitter will remain.
Controls for Navigation
• Use the roller, Back and Clear buttons near the LCD screen
for DX7s programming.
• Turn or press the roller to move through, select or change
screen content.
• Use the Back button to go to the previous screen (for
example, to go from the Mixing Screen to the Function List).
• Use the Clear button to change a selected value on a screen
to its default setting (Some values do not have a default set-
ting. For example, there is no default alarm type in the Timer
Screen).
• While the transmitter is powered on, go to the Model Select
screen by pressing the Clear and Back buttons at the same
time. This is Direct Model Access, and will let you go to the
Model Select Screen without powering off and on.
• Press and hold the roller while powering on the transmitter
to show the System Setup list. This list is usually used when
setting up a model and is not often used at the flying field.
No radio transmission occurs when a System Setup
screen is displayed, preventing accidental damage to link-
ages and servos during changes to programming.
• Powering on the transmitter without touching any controls
will show the Main Screen and the active model memory.
Press the roller while on the Main Screen to show the Func-
tion List.
NAVIGATION
Turn Press Press
Enter, Choose
or Exit
Move between
options or change
value in an option
Hold for 3
seconds and
release to move to
the Main Screen
Turn Hold Press
Accessing System Settings
The Model Select function is used to change to a different model
memory, typically when switching from the current model. You
can store up to 20 models in the DX7s model memory. Access
the model select function through the System Setup mode or
through Direct Model Access (pressing the Clear and Back
buttons at the same time). Direct Model Access allows you to
access the model select function at any time the main screen or
a telemetry screen is displayed.
Contrast
In the Systems Settings screen rotate the roller to highlight User
Contrast then press.
Rotate the roller to adjust the contrast (from 1 to 20) noting it on
screen. Press to accept.
User Name
User Name allows the identification of the owner to be pro-
grammed into the transmitter. The user name appears during the
startup process at the lower left corner of the startup screen.
To Program a User Name
In the Systems Settings screen rotate the roller to highlight User
Name then press.
Highlight the desired character position then press the roller to
access that position. Rotate the roller to change to the desired
character. Press to accept.
Repeat the process until the name is complete. Note that the
User Name displays on the lower left of the startup screen.
Mode
See Appendix for Mode Conversion.