Remote control, Before operation – Aiwa DINA Z-A60 User Manual

Page 5

Advertising
background image

ENGLISH

5

En

PREP

ARA

TIONS

REMOTE CONTROL

Inserting batteries

Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.

When to replace the batteries

The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.

To use SHIFT on the remote control

Buttons

1

have two different functions. One of these functions

is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the button
while pressing SHIFT.

To use FUNCTION on the remote control

FUNCTION substitutes for the function buttons (TAPE/DECK 1/2,
TUNER/BAND, VIDEO/AUX/PHONO, CD) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically.

1

SHIFT

FUNCTION

NOTE

• If the remote control is not going to be used for an extended

period of time, remove the batteries to prevent possible
electrolyte leakage.

• The remote control may not operate correctly when:

- The line of sight between the remote control and the remote

sensor inside the display window is exposed to intense light,
such as direct sunlight.

- Other remote controls are used nearby (those of a television,

etc.).

BEFORE OPERATION

POWER

6

STANDBY/ON

ECO

MULTI
JOG

ENTER

To turn the power on

Press one of the function buttons (TAPE/DECK 1/2, TUNER/
BAND
, VIDEO/AUX/PHONO or CD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
POWER is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.

To turn the power off

Press POWER

6

STANDBY/ON

Illumination guides

Whenever POWER or one of the function buttons is pressed,
the buttons for the selected operation light up or flash.
Example: When CLOCK is pressed,

a

SET,

f

and

g

light

up as a guide to setting the current time.

To change the brightness level of the display

1 Press ECO twice so that “DIM MODE” is displayed.
2 Within 4 seconds, press ENTER.
3 Within 4 seconds, turn MULTI JOG to select the dimmer mode

as below.

DIM-OFF

DIMMER 1

DIMMER 2

DIMMER 3

“DIM OFF” mode is the brightest and “DIMMER 3” mode is
the dimmest.
In “DIMMER 3” mode, the spectrum analyzer, and the button
illumination light off in addition.

4 Within 4 seconds, press ENTER to set the selected mode.

Advertising