Manual tuning – Aiwa DINA Z-A60 User Manual

Page 8

Advertising
background image

8

ENGLISH

MANUAL TUNING

POWER

MONO
TUNER

SHIFT

BAND

f

,

g

f

,

g

1

2

3

1 Press TUNER/BAND to select the FM or AM band.

When TUNER/BAND is pressed while the power is off, the
power is turned on directly (Direct Play Function).
To select a band with the remote control
Press BAND while pressing SHIFT.

2 Press TUNER PRESET repeatedly to select the

manual tuning mode.

Each time the button is pressed, the following three tuning
modes are selected cyclically.

1

Preset tuning mode: The preset number flashes.

2

Auto search mode: “SEARCH” is displayed.

3

Manual tuning mode: “SEARCH” is not displayed and the
preset number does not flash.

NOTE

The preset tuning mode is skipped if no station is preset.

3 Turn MULTI JOG clockwise or counter-clockwise

to tune in to a station.

The frequency changes as you turn MULTI JOG. When a
station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception,

1

is displayed.

f

DOWN and

g

UP are also available to tune in to a

station.

RADIO RECEPTION

To search for a station quickly (Auto Search)

Press TUNER PRESET repeatedly to display “SEARCH” (auto
search mode), and turn MULTI JOG clockwise or counter-
clockwise until the frequency starts to change rapidly. After tuning
in to a station, the search stops.

To stop the Auto Search manually, turn MULTI JOG a little in
either direction.
• The Auto Search may not stop at stations with very weak

signals.

f

DOWN and

g

UP are also available to search for a

station. Keep

f

DOWN or

g

UP pressed until the tuner

starts searching. Press the button to stop the search manually.

When an FM stereo broadcast contains noise

Press MONO TUNER on the remote control while pressing SHIFT
so that “MONO” appears on the display.
Noise is reduced, although reception is monaural.

To restore stereo reception, press MONO TUNER on the remote
control while pressing SHIFT so that “MONO” disappears and
“STEREO” is displayed for 2 seconds.

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER/BAND on the unit.
To reset the interval, repeat this procedure.

NOTE

When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.

Frequency

Preset number

SEARCH

SEARCH

MONO

Advertising