Error messages – Nikon S4200 User Manual
Page 196
E
88
Refere
Error Messages
The following table lists the error messages and other warnings displayed in the
monitor, as well as the solutions for dealing with them.
Display
Cause/Solution
A
O (flashes)
Clock not set.
Set date and time.
Battery exhausted.
Charge or change battery.
Battery temperature
high
Battery temperature is high.
Turn off camera, and allow battery to cool down before
resuming use. After five seconds, the monitor will turn
off, and the power-on lamp will flash quickly. After the
lamp flashes for three minutes, the camera will turn off
automatically. Pressing the power switch also turns off
the camera.
The camera will turn
off to prevent
overheating.
The camera has become hot.
The camera turns off automatically. Leave the camera
off until it has cooled and then turn it on again.
Q (
● flashes red)
Camera cannot focus.
• Refocus.
• Focus on another subject positioned at the same
distance from the camera as the intended subject.
Please wait for the
camera to finish
recording.
Camera cannot perform other operations until saving is
complete.
Wait until message clears from display automatically
when recording is complete.
–
Memory card is write
protected.
Write-protect switch is in “lock” position.
Slide write-protect switch to “write” position.
–
Not available if Eye-Fi
card is locked.
Write-protect switch of Eye-Fi card is in “lock” position.
Slide the write-protect switch to “write” position.
–
Error accessing Eye-Fi card.
• Use an approved card.
• Check that connectors are clean.
• Confirm that memory card is correctly inserted.