Nikon S4200 - Manual (Page 41)

23
Step 1 Turn the Camera On
B
a
si
c S
tep
s for S
h
oot
in
g
and Play
ba
ck
Turning the Camera On and Off
• When the camera is turned on, the power-on lamp (green) will light and then
the monitor will turn on (the power-on lamp turns off when the monitor turns
on).
• To turn off the camera, press the power switch. When the camera is turned off,
both the power-on lamp and the display turn off.
• To turn on the camera in playback mode, press and hold the c (playback)
button. The lens will not extend.
C
Power Saving Function (Auto Off)
If no operations are performed for a while, the monitor will turn off, the camera will enter standby
mode, and the power-on lamp will flash. If no operations are performed for approximately another
three minutes, the camera will turn off automatically.
To reactivate the monitor while the power-on lamp is flashing, press any of the following buttons:
- Power switch, shutter-release button, A (shooting mode) button, c (playback) button or b (e
movie-record) button.
• The time that elapses before the camera enters standby mode can be changed using the Auto off
setting in the setup menu ( A88).
• By default, the camera enters standby mode in about one minute when you are using shooting
mode or playback mode.
• If you are using the optional AC Adapter EH-62G (available separately), the camera enters standby
mode after 30 minutes (fixed).
0 0 88
50 50 50
Flashes
No operations
performed
No
operations
performed
Camera enters
standby mode Camera turns off
3 min